What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 17.06.2025 05:06

a photo is worth a thousand words.
These are simplified answers to the original question, and does not change anything I wrote above.
The bolt then partially travels down the line to your home.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
(Dc diagram shown, AC is similar).
What is the best way to get over your ex?
These devices are installed between the “hot” and “neutral” and protective ground.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Here is a simplified AC power diagram.
Edit 2024–10.
What are some ten strong legal evidences that are needed for a divorce?
2024–10–14 [Omar Gharbi Omar Gharbi ]
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
2024–10–10[John johnson John Johnson ]
so, what happens?
First Sentence:
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
This device then solves the entire problem.
what exactly is a ‘surge’ protector?
What does a fuse do?
Why is Taylor Swift re-recording her albums?
nine
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
I dreamt my mother had died and I cried so much in my dream. What does it mean?
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
One is “what exactly is in a ‘surge protector’ ? ”
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
There are two important concepts here.
This is 'the assistant's answer'
For this case there are devices called Metal oxide varistors (MOV).
When does a man tell a woman he has feelings for her?
An AC voltage/ current source, and an ac inductive load.
In schematic diagrams this is the symbol for a fuse:
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
How do you write lyrics for a song that resonates with listeners?
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
This one hit behind the barn.
the problem then depends on "how fast does the fuse operate?".
What is your favourite true story to tell at a party?
One
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
He then describes the function of a fuse.
The MOV will conduct when the voltage exceeds 50% of line voltage.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
He then asserts :
What is lightning?
2024–10–16 [ OO OLAOYE OYEBODE ]
[image of Common-mode choke]
The other is “what does a “fuse” do?”
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
This is where this question deviates from being a 'generic' question, and becomes more specific.
It seems Mohan does not understand the difference between a comment and an Answer.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
The third is lightning and “how it gets conducted into a home.”
A fuse is a non-resetable over current circuit protector.
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
But… the neutral is now “floating” because of the 1 ohm resistance.
So, the voltage could go up to 500 volts, and the fuse will not open up.
He then describes Rainy Season and Lightning.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
At one ohm, the resistor has a maximum of 1 watt power.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Upvotes:
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
There are three different concepts here that are getting confused.
but I think this circuit , shows a few more pieces.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
eight
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
I post the exact comment here.
But it can get overloaded, and no longer works.
It also is a device that limits the change in current flow.
At least they know the answer if they wanted it.
but this device (an Inductor) … impedes the rapid changes in the current.
[old diagram got deleted by accident]
This is where the MOV conducts again, and dissipated the energy.
Because the load is inductive, the current lags the voltage.(by a bit).
Barnstars:
Now when you have a certain ac resistance, then a current flows in a loop.
A circuit breaker is similar, but is resettable.